Tapped holes in periphery of flywheel

[inojim]

I'm brand new to eMachineShop, but am really jazzed over what can be done with the CAD software. I have watched the videos and made some trial drawings, but one part I need to make is a disc, about two inches in diameter and 3/8-inch thick, with three tapped holes into the 3/8-inch edge, equally spaced at 120-degree intervals around the periphery. How does one show this? Front/ back/left/right views are somewhat meaningless on a round part.

[Tech3]

Please use Comments to machinist to specify 2 holes not perpendicular to side views.

[inojim]

Thanks for that, Tech3. I am able to put my holes through the disc from the top, and can put one tapped hole in the rim from the front. But when I select the entire project and do a line/transform/rotate, the top view rotates, but the hole from the front doesn't. Isn't there a way to make the hole coming in from the side turn with the rest of the project?

[Tech3]

You can specify side holes in Left/Right/Front/Back views. Holes that are not perpendicular to these views planes should be speciifed using comments to machinist.