Sheet metal embossing

[nodott]

I have been working on this design for a gauge that is a reproduction of an older one that I have. In the middle there are two rectangular openings and I needed to know how does one refer to how the metal is rolled inward so I can ensure to the machinist when I send this in that they understand what I want. Or is there a way to express this in the drawing?

Maybe I can send them a picture along with it and have them refer to the picture.





Many Thanks
Lee[/img]

[Tech2]

You can refer to that as an embossed area and draw a side view of the cross section using Comments To Machinist.

[nodott]

Thanks for the info

Lee