Join in our community discussions. Anyone can browse our forums, but you will need to register a user account and login to post replies and original forum threads.
I'm having a hard time with the revolve feature when I try and recreate my original design. I seem to lose the center hole. Is there a trick with the revolve feature.
thanks,
ken
Last edited by eyeamred on Sat Jun 13, 2009 2:06 pm; edited 1 time in total
Tech3
Sat Jun 13, 2009 11:30 am
The design you attached does not have Revolve lines at all. Please clarify the problem.
eyeamred
Sat Jun 13, 2009 11:50 am
Attached is the new design. I can only see the center hole when I go into 3D Preview.The original design requires a center hole, but the new design takes it away for some reason. I need to know that if I submit this design, the center hole will be milled.
Tech3
Sat Jun 13, 2009 2:30 pm
Projecting Revolve onto the top/bottom view is planned. The hole will be turned according to your design. If you want it to be milled - remove revolve the line and specify the hole in top view using the [-- login to view link --] .
Last edited by Tech3 on Fri Oct 09, 2009 12:57 pm; edited 1 time in total
"Quite easy to use. Within only about 10 minutes I had it downloaded, installed, and had designed and priced a brass cog with 32 teeth, 1 inch in diameter and 1/4 inch thick. The quote was immediate."
Search
FAQ
Register
