Join in our community discussions. Anyone can browse our forums, but you will need to register a user account and login to post replies and original forum threads.
I'd like to specify #00-90 tapped holes.
I have tried to use the User defined method (under Machine, Thread & Tap )
I specify either 00 or, #00 as the size and 90 as the TPI. But I consistently get a message that says that the thread parameters I specified are not valid.
How should th 00-90 thread be specified?
Tech3
Thu Sep 03, 2009 5:43 am
Use comments to machinist - [-- login to view link --]
"Thank you. I hoped that there was this kind of service on the net and there you are. And it wasn`t hard to find you. The term "sheet metal online order part" did the trick."
Search
FAQ
Register
