Join in our community discussions. Anyone can browse our forums, but you will need to register a user account and login to post replies and original forum threads.
Sat Feb 27, 2010 10:37 am dxf file conversion problems
Hi All,
I imported a dxf file for a guitar amplifier chassis. It is a proven diagram and 95% accurate for my application. I just need to move a couple of the holes. I read the limitations on using this file type and then tried to look at it 3D. After I had gone through as many of the conversion instructions as I could, there was very little left of the original drawing. I'm not sure I even need to see it in 3D but the pricing wizard needs the same changes.
Is there a way to use the original CAD drawing or do I need to start from scratch?
Thanks, Skip
Tech2
Sat Feb 27, 2010 11:26 am
I doubt anyone can help you without posting the file to this forum.
Last edited by Tech2 on Sun Feb 28, 2010 10:36 am; edited 1 time in total
"I did the attached drawing in under 5 minutes. Great... The drawing is very easy, intuitive, and enjoyable. I whipped up a design and got a quote in under 60 seconds!"
Search
FAQ
Register
