Creating a conical shape half way up a cylinder?

[m2silva]

Hello, I'm new here. I love the eMachineshop software...still getting used to it.

Wondering if anyone is able to lend a hand on a little project of mine?

I've designed a cylinder that is 1.875" in diameter, and 1.5" in length, inner diameter is 1.375".

I would like to create a conical shape from the middle length of my cylinder at the .75" point, to the upper half at 1.5".

I would like the bottom conical diameter to be 1.75", (bottom will have a .25" decreasing step in diameter from the 1.7/8" or 1.875 inch diameter) and the top diameter to be 1.5".

How can I accomplish this?

Attached is my cylindrical drawing so far.

Would appreciate any guidance!

[Tech3]

Please review Revolve.

[m2silva]

I had initially tried this tutorial but had failed in making it work successfully, however, after reading it carefully a few times, then trying it out in FRONT view (2D) a few times, using Revlove, I was able to finally get it working.

Thanks tech 3!

Here's the end result. (With some other adjustments).