Join in our community discussions. Anyone can browse our forums, but you will need to register a user account and login to post replies and original forum threads.
Hi - In the attached design, I have two openings that need to be drilled out at a 45-degree angle. I know the software won't yet allow me to draw that, so I'm limited as to how to show these in the file. Before submitting the final design, I just want to make sure my Comments to Machinist make sense.
Comments to Machinist are clear and acceptable. You can proceed with placing an order.
RSS
Wed Feb 10, 2010 2:32 pm
Excellent, thanks.
Tech2
Wed Feb 10, 2010 4:33 pm
Hmmm - not so fast Tech3. In the Left view change the arrow lines to non arrows and put in the exact desired position and depth and don't cross the ends of the lines. Also include a dotted center line as the center of the current lines does not match the other view.
"Quite easy to use. Within only about 10 minutes I had it downloaded, installed, and had designed and priced a brass cog with 32 teeth, 1 inch in diameter and 1/4 inch thick. The quote was immediate."
Search
FAQ
Register
