I am having a lot of trouble finding a specific fitting for a project I am working on, and am looking for a custom option. We will be buying a lot of these so I am not worried about setup cost. Essentially I want a 4" flush fit x 3/4" npt reducer bushing in ABS.
So the main body of the part will insert into a sch 40 ABS pipe, and be solvent welded. I know that 4" sch 40 pipe has a listed ID of 3.998", but does anyone know what a good diameter and tolerance is for the OD of the fitting so that it can dependably be solvent welded into the pipe?
I have attached a diagram for clarity.
Engineering issues - formulas, data, approaches, etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest