disk with steps

Creating flat drawings - bisecting angles, making tangent lines, complex centering, etc.
Post Reply
Posts: 14
Joined: Thu Jul 05, 2012 8:08 pm

disk with steps

Post by jekain314 » Mon Dec 17, 2012 10:53 am

I want to make a 6 inch AL disk with 0.5 in thickness at the outer diameter. Then I want to step down to 0.25 in thickness leaving a 0.25 in annular outside ring.
I cant seem to figure out the z-dimension input of the rings.

Posts: 458
Joined: Tue Nov 04, 2008 5:48 am

Re: disk with steps

Post by Tech3 » Mon Dec 17, 2012 1:01 pm

Please review Revolve.

Post Reply