Holes in Hollow Cone At Irregular Intervals

Engineering issues - formulas, data, approaches, etc.
Post Reply
Posts: 1
Joined: Wed Aug 23, 2017 7:56 pm

Holes in Hollow Cone At Irregular Intervals

Post by ft4jsde » Wed Aug 23, 2017 8:16 pm


I've been working on a hollow cone design that requires three different sized holes every 120 degrees. Is there a way to do this? I have attached the ems file of what I have designed so far. The Top view shows the guidelines where the holes need to go, and I believe I have figured out how to design the holes on the front face - it's designing the holes at the other 120 degree intervals that's tricky. Any tips would be great. Thanks!

(15.37 KiB) Downloaded 167 times

Post Reply