Home/Resources/CAD Help/Line Types/Standard finish

Standard finish

For 3D machined parts with no finishing specified, the eMachineShop machinist will use discretion whether to vibratory tumble parts or leave parts as machined. It is generally recommended to leave the decision to the machinist.

tumble_finish machined_finish

Vibratory tumble

This finish does the best job of removing sharp edges and burrs and is more economical as it does not require machining chamfers to avoid sharp edges. (Chamfers were however machined in this example.) 

As machined

This finish has a machined appearance. If you choose this finish it is strongly recommended, for safety, to include in your design chamfers on all edges to break sharp edges (this increases machining time and hence cost). This finish requires special handling which also adds to cost. You can request this finish under Job | Finishing | Machined Finish. 

Please note that the finish for each particular design or run will likely vary slightly from the above examples which are displayed only for general guidance.

Was this information helpful?  YESSOMEWHATNO
SitemapCareersSuppliersPrivacyTerms of Use and Order Policies
eMachineShop | 31 Industrial Ave. | Mahwah, NJ 07430
Questions? Contact us
Subscribe and Get the Latest Tips, Updates and Tutorials.
Get the free easy-to-use eMachineShop CAD software and start designing your parts in minutes.
Video Tutorial Watch our brief introduction showing how to design, price and order custom parts at eMachineShop.
Design you printed circuit boards at our PCB division Bare boards or fully assembled.
Copyright © 2017, eMachineShop. All rights reserved.