Outer Edge Fillets

[Gobc]

How do you apply a fillet on only 1 or 2 edges of an outside edge? I can only apply the fillet over the entire outer edge of my part.

I also cannot see any outer edge fillets. I could only see them when I exported my model as a STL fiew and viewed it with another program.

[Tech3]

1. See Comments to Machinist
2. Please post the design with near edge round that is not shown in 3D preview.

[Gobc]

I did manage to figure it out, but it wasn't easy. Its quite ridiculous that your software forces you to apply a single cut over an entire boundary instead of just over a line or arc. I highly recommend you change this. You will see what I mean when you render the part.

[Tech2]

Thanks for your suggestion. We plan to add that capability.

[dpalchak]

@gobc: How did you do it? I am having the same problem. I want to create a simple rectangular piece of aluminum with a chamfer on a single edge. However, the program seems to only let me chamfer the entire perimeter of the part. How can I chamfer just a single edge?

Thanks,
David

[Tech3]

Please review Air outside.